![Cool 8)](./images/smilies/icon_cool.gif)
Now the thing is, sometimes i think i am applying a bit too much gas . I have this fear. i will put numbers to make it easer
1.Reach 2000rpm in 1st then push clutch in/let the gas out than move shifter to 2nd
*Be slow so the rpm get to idle ( for whatever reason, traffic/things, just take this as is)
2. Apply the amount of gas that holds the rpm to 1200rpm
3.Release the clutch pausing at the fp, the clutch drags the rpm to 1000rpm and i get a small acceleration but it feels nice/smooth
4.Fully release the clutch after i feel it sync
This only happens like 20% of time but still i want to know just to extend my knowledge
![Very Happy :D](./images/smilies/icon_biggrin.gif)
Is this the same as dragging the rpm held by rev hang (i dont have it )
Or Is this "applying power through a slipping clutch"? I have seen the videos here and that guy says you can damage the clutch in 1-2 shift because you get excited and you put the foot to the floor (i guess he means you give it full throttle or close to that)
Shortly: i fail to understand the difference between overshooting rpm by a steady throttle and overshooting them by a blip. But here is the video that doesn't think like me and it is scaring me
![Confused :?](./images/smilies/icon_confused.gif)